Featured Videos
-
Medical Eye Surgery
1/26/2017
In this video, Jimmy Green, an OEM Specialist, shares how Ophir Photonics assisted a lasik surgery company replace a plastic mode burn pre-test with an accurate laser measurement device.
-
Medical Device Quality Control
1/26/2017
In this video, Jimmy Green, an Ophir Photonics OEM Specialist, discusses an OEM solution provided to a customer that allowed for medical laser power development before and after procedures that ensured the proper outcomes.
-
Quality Control 4X Throughput
1/26/2017
In this video, Dick Reiley from Ophir Photonics shares how he provided a manufacturer a solution that allowed throughput to increase 4X by reducing the time required for quality inspection. This solution was specifically created for an application measuring laser diodes.
-
Laser Measurement Best Practices: Thermal Offset Due To Sensor Heating
7/6/2016
Thermal sensors are designed to measure the power of lasers according to their heat measurements. In some cases, the sensor may be heated due to environmental causes and result in an incorrect laser power measurement. This video provides a set of best practices to assume in order to get the most accurate thermal sensor readings every time.
-
Co-alignment Of Visible, NIR, And IR Laser Beams
4/22/2016
Eric Craven with Ophir Photonics provided us with a tutorial at DCS 2016 on how to co-align visible, near-infrared, and infrared laser beams through the use of a pyroelectric camera array coupled with beam profiling software.
-
Why Do I Need To Measure My Laser Beam?
2/17/2016
Dan Ford walked us through some of what was on display for laser beam profiling and analysis applications before sharing information on Ophir’s high-power laser application initiative over the last year.
-
Video: The Full Spectrum
11/23/2015
Ophir-Spiricon products have the ability to measure the output for every laser wavelength along the electromagnetic spectrum. This video provides a brief introduction of Ophir’s wide range of equipment used in different spectrum regions to measure and profile lasers.
-
Video: Does Damage Threshold Depend On Power Level?
11/23/2015
Does the power density damage threshold really change with power? Shouldn’t it remain the same throughout the whole power range? This video presents evidence suggesting that the specified damage threshold does depend on the power level, and not just power density.