Product/Service

High Precision Tubing Extrusion

Source: Harrel, Incorporated
With Tube-Trol systems, you key in the outside diameter, inside diameter and length.
What is Tube-Trol? Tubing systems from others give you control of the extruder. Getting the system onto dimensional targets involves a repeated trial and error process -- making tube, measuring it, readjusting the extruder, making another sample, measuring it, adjusting the extruder again, etc.

Not so with Harrel Tube-Trol systems. With Tube-Trol systems, you key in the outside diameter, inside diameter and length. The system will automatically bring you on target in 3-5 minutes and hold you there, hour after hour, without operator intervention!

Tube-Trol systems have a number of forms:

  • Standard Tube-Trol
  • Multi-Lumen Tube-Trol
  • Coextrusion Tube-Trol
  • Bump Tube-Trol
  • Double Bump Tube-Trol
  • Alternate Polymer Tube-Trol

Duostrand Tube-Trol

  • Two identical tubes, side by side.
  • Ideal wherever downstream equipment limits speed of line -- Simply split into two strands.
  • Same close, automated control of OD, ID, and length.
  • Only requires one water bath, laser gauge, puller, and cutter!
  • Double the throughput for about 15% increase in cost. That's good arithmetic!
Tube-Trol Upgrade Systems · Upgrades existing tubing extrusion lines for bump tubing Tube-Trol. · Same automated, close-tolerance control of OD, ID, and length of both bump and stem, plus programming of transitions, as in Harrel Tunkey Bump Tube-Trol lines.

Harrel, Incorporated, 16 Fitch Street, Norwalk, CT 06855. Tel: 203-866-2573; Fax: 203-866-1483.