OK Medical Sealer
Source: O/K International Corporation
The OK Medical Sealer is a fixed speed, continuous hot air sealer designed to meet the requirements of FDA process validation guidelines.
The OK Medical Sealer is a fixed speed, continuous hot air sealer designed to meet the requirements of FDA process validation guidelines. The OK Medical Sealer does not use Teflon coated bands. This means less replacement cost and decrease in downtime. The removal of bands also means less particulates in the clean room. The sealing temperature is fully PID controlled and the seal pressure is air regulated, allowing for complete system calibration of the dynamic parameters which affect the seal integrity. New in 1999 was the addition of a pressure switch on the front of the machine. If the air were to fall out, the machine would reverse. Also new is the addition of a full procedure manual.
O/K International Corporation, 73 Bartlett St., Marlboro, MA 01752. Tel: 508-303-8286. Fax: 508-303-8207.
This website uses cookies to ensure you get the best experience on our website. Learn more